The ultimate trigger kit for the EAA Witness - Tanfoglio pistols includes EGW's Hammer and Sear that has been prepped by EGW, HENNING X-Long Firing Pin, 13lb Wolff Hammer Spring. The hammer is made from barstock. The hard sear is hardened to Rockwell 55, reset leg been cut back and sear face polished. It will give you a consistent trigger pull for a long time. The 13lb Wolff Hammer Spring reduces your new nice trigger pull considerably and the X-Long Firing Pin gives you 100% consistent ignition. The Trigger Kit can be expanded by including the new hardened hammer and sear pins. They are oversized so a reamer must be used to install. The hardened sear pin keeps the sear tight in the sear housing which helps control the trigger part. The hardened hammer pin holds the hammer in the frame tightly. This kit should be installed by a gunsmith, sear will require a fitting to thumb safety. For additional lightening of trigger pull and creating the trigger pull you truly desire, the sear face will need stoning/polishing. The trigger reset can also be shortened more by working the sear.

EGW offers a custom made, carbide sizing dies that are 0.001" smaller in diameter than typical dies. These dies also flair lower than some other sizing dies and size the case further down, which may prevent feed failures from cases bulged near the base as is typical of brass fired in Glock and other loose chambered guns.

A must for the serious competition reloader.