Factory slide stop. Available either in blued or "chrome look" pictured, depending on what I have in stock.

Henning's TiteFit Slide Pin is made out of shock-resisting S7 tool steel and hardened to Rockwell 45. The OD is 0.198" (factory 0.195") which ensure a tighter lockup of the barrel. It is made to only sit 0.020" proud on each side of the frame so it will look good and make the gun slick and not snag on anything like the factory or EGW pin does.

EGW's hardened slide stop pin replaces the factory slide stop. If you are running Gram's follower & spring kits, you'll need this slide stop.

This is an extra long (extended) magrelease which is the current magrelease found on Gold Team and Limited models. In 2004, the mag release was redesigned. The new design positions the magazine higher in the frame and improves feeding. Especially beneficial for 40 S&W caliber. Available in "chrome look" finish only.

This is for a LARGE FRAME ! If you are not sure what frame you have, check your mags. Large Frame Mags measure: 1.345" x 0.850".

Standard style magrelease. This is the same mag release you will find on Stock, Steel and older models. Available in blued finish only.

This is for a LARGE FRAME ! If you are not sure what frame you have, check your mags. Large Frame Mags measure: 1.345" x 0.850".

Factory spec for EAA Witness Gold Team and Limited. Could be post-fitted to Match and Stock by a gunsmith.

This is for a LARGE FRAME ! If you are not sure what frame you have, check your mags. Large Frame Mags measure: 1.345" x 0.850".